Graphite Electrode With Nipples for E.A.F From Factory

Grate electrode is made of high quality petroleum coke and pitch. This product goes through the process of calcining, matching, blending, modeling, baking, gratization and machining and etc before it rolls off the nipple of the electrode takes the technology of three-time impregnating and four-time baking to produce.

Introduction: Artificial grate electrode is made of high-quality low ash materials, such as petroleum coke, needle coke and coal pitch. After calcining, burdening, kneading, forming, baking and pressure impregnation, it is gratized in a high temperature of over 3000°C, and then treated with machining. Such of the products own characteristics with low resistivity, good electrical conductivity, low ash, even and compact structure, good anti oxidation and high mechanical strength.

Strong points that electrodes with other components can not reach: 1.Good thermal stability, the electrode will reach 3,000 degrees Celsius and sublimate at 3550 degrees, which the metal can not withstand this incredible temperature. 2.Low resistivity, only several ohms, which leads low consumption during melting. 3.light, with density of quarter of that of copper. It is easier for delivery and convenient for holding when operation on furnace. 4. materials as pitch, petroleum coke are easy to get. 5.easy machining, high speed is triple or five time than that of other common metals.

Important data: 1. Density: The density of a material helps to distinguish it from other materials. Since mass is usually expressed in grams and volume in cubic centimeters, density is expressed in grams/cubic centimeter. In this call bulk density. 2. Mechanical strength: It refers to the compressive, flexural and tensile strength. When the external object and the vertical axis,the first bending moment of break the limit of resistance is as flexural strength (or bending strength). Experience shows the strength of the bending is twice than the flexural strength, which is twice than the tensile strength. 3. Modulus: refers to the material within elastic deformation, stress and strain as the ratio of the elastic modulus. Not only to upgrade the mechanical strength but also to make elastic modulus controlled in a certain context is a tough question for grate electrode production process. 4. Electronic resistivity: also called resistivity. 5. Thermal conductivity: The material tests specimen under the unit gradient of temperature, when the unit area the quantity of heat which transmits in the unit time. 6. Thermal expansion coefficient: The inflated heating degree of measurement when materials are heated. When the temperature is elevated a ?, which leads unit length solid material samples in a particular direction on the expansion ratio constant, called on the direction of the pansion coefficient. It consists of pansion coefficient and radial expansion coefficient. At present, our country tests pansion coefficient with test temperature in 100-600 ?. (In some other countries, it is tested under the conditions of 30-100 °C. 7. Property that carbon and grate products used in high temperature can withstand temperature changes without being damaged as thermal shock resistance, which sometimes also called "cooled rapidly heat-resistant" or "thermal stability." The existence of thermal expansion of carbon and grate products undermines the fundamental reasons at temperature fluctuations. If rapid cooling from high-temperature, surface products is produced by the contraction of shrinkage stress, on the contrary, from low to high, under rapid change, will produceIndices Of sical And Chemical Properties Of Grate Electrode