HIGH SPEED STRAIGHTENING & CUTTING MACHINE

HIGH SPEED STRAIGHTENING & CUTTING MACHINE

Double ning Cutting Machine Manufacturer

Double ning Cutting Machine Supplier

HIGH SPEED STRAIGHTENING & CUTTING MACHINE use the high speed rotating spinner to make straightening. This machine make straight bar from coil in high efficiency.

STRAIGHTENING & CUTTING MACHINE PRINCIPLE

1.CENTRAL MACHINE

2.pan>

Maximum carrying capacity 2,000Kg.Equipped with safety funnelEquipped with 1set of vertical payoff and 1set of guide funnel3. D UNIT

Two independent incoming towing devices.Each device is made up of two pulleys whose aim is to feed the the rotating unit.The pulley is equipped with two races whose profile depends on the shape and dimensions of the cessed.The upper pulley pressure is adjusted by screw and pneumatic clamping.

4.STRAIGHTENING ROTATING BODY

The most important component of the machine.There are five couples of dies inside the body. The machine is normally supplied with two types dies (standard cast-iron dies) for the process of the small and large span>

5.ED UNIT

Out-feed unit is made up of two pulleys whose aim is to drag the rotating unit to the cutting unit.

The pulley is equipped with two races whose profile depends on the shape and dimensions of the cessed.

The upper pulley pressure is adjusted by screw and pneumatic clamping.

The cut unit is made up of an arm within which there is cutting knife, moved by an independent servo-motor operating on a can cutting the quired length.

6.CUTTING UNIT& COLLECTING BENCH

12m collecting bench with preselecting rod counter (buffering device) and collecting pocket.

The cutting control device (length measuring) is mounted in the frame. Any required length between 1,000-12,000mm can be setup manually.

7.ELECTRIC CABINET AND CONTROL CONSOLE

Siemens electric cabinetButton and touchable screen coordinated operation system