Mcu reverse LPC1752

We are a high-tech enterprise specializing in chip decryption, IC decryption, single-chip decryption, CPLD decryption, the chip identification and MCU program design, chip burn and IC circuit board supporting the original supplies, PCB design, PCB processing debugging service, etc.The company is backed by advanced decryption equipment and professional decryption technology and years of research and development.To provide you with the chip decryption service and various new types of single-chip decryption development .We constantly sum up experience, with unique mode of operation, good professional, high quality brand service, insist on the enterprise culture promotion enterprise core competitive ability, make the enterprise set up good social image in developing .<br /><br /><br /> ARM Cortex-M3 processor, running at frequencies of up to 100 MHz<br /> ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)<br /> Up to 64 kB on-chip flash programming memory<br /> Up to 16 kB of SRAM<br /> In-System Programming (ISP) and In-Application Programming (IAP)<br /> Eight channel General Purpose DMA controller (GPDMA)<br /> Multilayer AHB ect provides a separate bus for each AHB master<br /> Split APB bus allows high throughput with few stalls between the CPU and DMA<br /> USB 2.0 full-speed device controller<br /> Four UARTs with fractional baud rate generation<br /> CAN 2.0B controller with one channel<br /> SPI controller with synchronous, serial, full duplex communication<br /> Two SSP controllers with FIFO and multi-protocol capabilities<br /> Two I2C-bus interfaces supporting fast mode with a data rate of 400 kbit/s<br /> 52 General Purpose I/O (GPIO) pins with configurable pull-up/down resistors<br /> 12-bit Analog-to-Digital Converter (ADC) with conversion rates up to 200 kHz<br /> Four general purpose timers/counters<br /> One motor control PWM with support for three-se motor control<br /> Quadrature encoder interface that can monitor one external quadrature encoder<br /> One standard PWM/timer block with external count input<br /> Real-Time Clock (RTC)<br /> WatchDog Timer (WDT)<br /> ARM Cortex-M3 system tick timer, including an external clock input option<br /> Standard JTAG test/debug interface<br /> Integrated PMU (Power Management Unit)<br /> Four reduced power modes<br /> Single 3.3 V power supply (2.4 V to 3.6 V)<br /> One external interrupt input configurable as edge/level sensitive<br />