MAL20*50

MAL20*50

QPC MAL Series Pneuamtic Actuator Aluminium Alloy Mini Cylinder_QPC MAL Series Pneuamtic Actuator Aluminium Alloy Mini Cylinder

MAL Series

Aluminium alloy mini cylinder

※Installation and application

1. When the load has change during work, it is necessary to select the cylinder with sufficient output force;

2. At high temperatures or corrosive conditions, it is necessary to select the corresponding high-temperature resistance and corrosion resistance cylinder;

3. In the cases of high humidity, excessive dust, or water drop, oil dust, and welding slag, necessary protective measures shall be taken for the cylinder;

4. Before connecting the cylinder to the pipeis necessary to remove dirt in the pipevoid impurity entry into the cylinder;

5. Medium for the cylinder can be used after being filtered by the filter um;

6. In low temperature environment, it is necessary to take antifreezing measures to prevent water freezing in the system; .

7. Before use, the cylinder shall undergo no-load test run; before running, it is necessary to adjust buffer to a minimum and then gradually loosen it to avoid cylinder damage due to too large impact;

8. Avoid the lateral load, otherwise the piston rod will be bent and deformed and damage the rod end thread. The single action type can't be loaded in return stroke

9. When the cylinder is removed and not used for a long time, it is necessary to pay attention to the surface rust; in addition, air inlet and exhaust port shall be applied with dustproof plug cap additionally. Pay special attention to that front and rear covers can?t be removed.