TSGC2 Series three-phase voltage regulator

Scope

TSGC (2) Series regulator has a beautiful appearance, waveform distortion, small size, light weight, high efficiency, easy to use, reliable operation, superior performance, can be widely used in industry (eg chemical, metallurgy, instrumentation, electrical and mechanical manufacturing, dimming and power control purposes, is an ideal AC voltage power supply three-se voltage regulator structure, three-se voltage regulator assembly consists of three units of the same size from the shaft regulator winding connected to the star.

The main technical parameters ①basic parameters of the regulator following table provides ② regulator rated (output) capacity: regulator rated Capacity is calculated as follows: P = m12 * U2 * 10-3 (KVA) Where: P- regulator rated output capacity (KVA) m- se, single se m = 1; three-se m = 3 I2- rated output current (A) U2 maximum output voltage (V) (three-se age) ③ regulator Insulation class: regulator insulation class A grade average coil temperature limit of 60 ℃. ④ overload capacity, voltage regulator allows the output current exceeds the rated short time, but can not exceed the following table. 三、Main technical characteristics 1.Fundamental

Regulator turns ratio is continuously adjustable autotransformer, by the action of the brush when the regulator hand wheel spindle and brush holder, polished surface sliding along the ring, you can continuously change the turns ratio, so that the output voltage is adjusted smoothly from zero to a maximum value.

2.The main structure

a unit Festival: 0.2KVA 10KVA single se voltage regulator to regulator for regulating structure, a polished surface of the upper end of a coil fixed certain width in engineering base, brush group under spring pressure polished surface coil in close turn the hand wheel to drive the brush on the polished surface of the coil slide the regulator, the regulator is usually a desktop unit, outside the protective hood.

b Single-se assembly structure: single-se high-capacity regulator system assembled from several units from the same specification, the brush assembly of the units on the same axis, the coil is connected in parallel to the input terminal, an output terminal connected to balance reactor to the balance between the current distribution and inhibit circulation unit.

c Three-se assembly structure: three-se voltage regulator by means of coaxial assembled from three identical specifications

d brush structure:. 3KVA and below the unit regulator, using 1 to 2 grate brushes and good metal cooling rack, 4KVA and more units regulator, using two copper-grate composite brush, brush group fixed coil upper platen and limit its axial position, through the spindle locking screw, when it needs an overhaul, exchange or need major axis spindle extends from the bottom of the regulator when, just loosen the screws, you can convenient operation.

Working conditions1. The altitude does not exceed 1000m. 2. The ambient temperature is not higher than 40 ℃. 3. Air relative humidity less than 85%. 4. does not contain chemical corrosive gases and steam environment. 5. No explosive gas. 6. occasions against water intrusion. 7. Can not be used in parallel. Dimensions

Rated Capacity	L1 (mm)	Width L2 (mm)	Long L3 (mm)	High H2 (mm)	Weight (Kg)
1.5KVA	120	135	145	300	7.5
3KVA	125	135	155	300	7.8
6KVA	170	210	210	480	25
9KVA	200	240	260	480	35
15KVA	230	260	290	550	55
21KVA	230	260	290	630	66
24KVA	230	260	290	655	70