New Generation Scientific Laboratory Instruments

Features:1. Low cost.2. Reacting Temperature: -80~300?3. Mechanical sealing.4. Explosion-proof device is optional.5. AC Motor, brushless, no sparkle.7. Constant rotating speed.8. Precise Temperatue control9. Easy operation.

Brief Introduction:Single glass reactor inner placed reaction solvent which can be stirred, interlayer can be filled with cold or hot liquid(frozen liquid, water, gas or hot oil) to do the thermostatic heating/cooling reaction, single layer glass reaction kettle is heated by computer control oil bath or electric heating. At the same time, it can be worked at atmosric pressure or vacuum state, to control the reaction solution reflux and distillation, it is the ideal equipment for modern synthesis chemical, biological rmaceuticals and making new materials, used for preparation experiment and production equipment.

Working principle:Under the condition for setting the constant temperature, in a closed glass container, at atmosric pressure or negative pressure by stirring, reaction, it can control the reaction solution's evaporation and reflux.

Heating principle:The heating coil in the tank heat the transfer medium-water or oil directly,(heating mantle heat the body kettle). Then the hot water or oil pass its hot energy to material in the kettle and stirring at the same time.

Notes:1.Please check whether the glass kettle intact or not, whether each interface is consistent or not. Please handle with care. 2.Wipe each interface with a soft cloth (napkin available),then apply a little vacuum grease.( Vacuum grease must be covered to prevent gray sand from entering after using.)3. Each interface can not be over-tightened, loosening them periodically, avoid long-term furrowed causing connector tightened deadly.4.First turn on the power switch, and then let the machine run from slow to fast speed. When the reaction is over, let the machine into static state, then off the switch.5.Every PTFE switch can not be over-tightened, which is easy to damage the glass.6.Please wipe the various traces of oil, stains, solvents left on surface to stay with a soft cloth after you completing the experiment.7.After the shutdown, loosen each PTFE switch. Long time keeping still in working condition causes PTFE piston deformation.8.Clean seals regularly.Method: Remove the seal ring, check the shaft plot dirt or not, wipe it with a soft cloth, then coat with a little vacuum grease, and re-install it to keep the shaft and seal smooth.9.Keep the electrical parts dry, non-moisture!10.It’d better purchase the original authentic parts,use other machine parts may cause fatal damage.11.Any repair or inspection be sure to cut off power and water.12.Explosion-proof is optional.

Function:1. Vacuum stirring reaction2. High and low-temperature reaction3. Constant speed running mixing reaction4. Distillation, refluence and condensation5. Negative pressure operation and separation6. Rectify through assembling the rectifying pillar7. Assembly of the production ccordance of specific demands.

Ancillary equipment:

Circulating water vacuum pump: Used to provide a vacuum sourceCool chiller: Reflux, condensation and cool the material

10L-100L Single Layer Glass Reactor:

Explosion-proof Single Layer Glass Reactor is available~