Blue | Two-component |
product manual:
AMS-99 is a transparent glass heat-insulating coating made of high-performance insulating mesor GTO nano material. It has high heat insulation performance and good transparency. The infrared film has a dry wavelength of 3 microns and the infrared wavelength is 1400nm. The blocking rate is 99%; the IR infrared blocking rate in the near-infrared region at the infrared wavelength of 900 nm is over 85%. The coating has intelligent spectral selectivity and stability, high hardness and transparency of the film layer, high performance blocking infrared and ultraviolet rays, energy saving, environmental protection, flame retardant, noise isolation, long service life, no fear of water, no fear of acid and alkali, Convenient construction and easy to promote. The advent of this product will surely achieve more effective winter and cool summer in the field of window glass, such as architectural glass and automobile, which will save energy and create a more comfortable, environmentally friendly and energy-saving indoor environment.
 Main performance parameters:
Indicator name
Performance parameter
Exterior
Blue liquid (two-component)
Main ingredient
GTO nano-insulation medium
Insulation: infrared blocking rate
â¥99% at 1400nm; â¥85% at 900nm
value
7.0±0.5
proportion
0.9 g/cm3
Transparency: visible light transmittance
â¥65%
UV blocking rate
â¥99%
hardness
5-6H
Adhesion
Level 0
Noise reduction
15-20 decibels
Coating thickness
2-3μm
Membrane life
20 years
Construction area
40m2/L
The main purpose:
It is used for energy-saving renovation of architectural glass to reduce energy consumption.
Used in architectural glass, solar glass, glass curtain wall, high-grade hotels, hotels, office buildings, private homes, exhibition halls, etc. to improve comfort and energy efficiency.
Used for heat insulation and UV protection of vehicles, trains, airplanes, ships and other vehicles to improve comfort and energy efficiency
It is used in indoor glass that needs to block and shield ultraviolet rays.
Instructions;
The glass to be constructed should be cleaned before construction, and the surface can be dried without moisture. .
Mix the A and B components according to the requirements of the product specification, and then stir them for 10-20 minutes before using them.
Prepare the sponge scraping tool and the sump, pour the paint into a clean sump, and apply a proper amount of paint to the top and bottom.
After mixing the A and B components, it is best to use them within 3 hours. Otherwise, the viscosity of the coating may increase and it is not easy to use.
Precautions:
1. Selection of construction surface:
Single-layer glass: both indoor and outdoor.
Double glazing should be chosen for outdoor construction.
2. Transport preservation method:
The product should be kept in a cool place as much as possible.
The ambient temperature is valid for three months from 25 degrees to 35 degrees.
Valid for 6 months when the ambient temperature is 5 degrees to 15 degrees
3, applicable substrate:
Transparent glass, transparent acrylic, transparent PET, transparent PP
Be protective when using it to prevent it from entering your mouth and eyes.
 Packing specification
1/2/20 liter