Blue | Two-component |
product description:
AMS-020 glass heat-insulating coating is a normal temperature self-drying type of paint coating, which is cost-effective and combines various advantages of coatings. It is a general-purpose product under normal working conditions. The coating has intelligent spectral selectivity and stability, high hardness and transparency of the film layer, high performance blocking infrared and ultraviolet rays, energy saving, environmental protection, flame retardant, noise isolation, long service life, no fear of water, no fear of acid and alkali, Convenient construction and easy to promote.
Main performance parameters:
Indicator name
Performance parameter
Exterior
Blue liquid (two-component)
Main ingredient
Nano-insulation medium
Insulation: infrared blocking rate ⥠85%
value: 7.0±0.5
Specific gravity : 0.9 g/cm3
Transparency: visible light transmittance â¥80%
UV blocking rate â¥99%
Hardness: 5-6H
Adhesion: 0
Noise reduction: 15-20 decibels
Coating thickness: 4-5μm
Film life: 20 years
Construction area: 40m2/L
The main purpose:
It is used for energy-saving renovation of architectural glass to reduce energy consumption.
Used in architectural glass, solar glass, glass curtain wall, high-grade hotels, hotels, office buildings, private homes, exhibition halls, etc. to improve comfort and energy efficiency.
Used for heat insulation and UV protection of vehicles, trains, airplanes, ships and other vehicles to improve comfort and energy efficiency
It is used in indoor glass that needs to block and shield ultraviolet rays.
Instructions;
The glass to be constructed should be cleaned before construction, and the surface can be dried without moisture. .
Mix the A and B components according to the requirements of the product specification, and then stir them for 10-20 minutes before using them.
Prepare the sponge scraping tool and the sump, pour the paint into a clean sump, and apply a proper amount of paint to the top and bottom.
After the A and B groups are allocated, it is best to use them within 3 hours. Otherwise, the viscosity of the coating may increase and it is not easy to use.
Precautions:
1. Selection of construction surface:
Single-layer glass: both indoor and outdoor.
Double glazing should be chosen for outdoor construction.
2. Transport preservation method:
The product should be kept in a cool place as much as possible.
It is valid for 3 months when the ambient temperature is 25 degrees to 35 degrees.
Valid for 6 months when the ambient temperature is 5 degrees to 15 degrees
3, applicable substrate:
Transparent glass, transparent acrylic, transparent PET, transparent PP
Be protective when using it to prevent it from entering your mouth and eyes.
Packing specification
1/2/20 liter