Rubber water stopper

Buried in the rubber water-stop requires strong self-adhesive, is suitable for the high temperature of the temperature of the four seasons is not flowing, not crisp characteristics of the low temperature, and exnt water resistance, acid and alkali resistance and aging resistance;The section of the rubber layer should adopt the non-equal thickness structure, the strength zone, the waterproof area and the installation area, make the force uniform, reasonable, not broken.Long service life, the product itself is not or the environment.Â

After the pre-treatment of galvanized steel strip was inserted into the rubber intermediate vulcanization forming, the adhesion of the two was strong and the effect was obvious.The intermediate rubber body of the embedded steel side water belt is compressed, stretched and deformed when the structure is deformed, and it ACTS as seal and stop water.Galvanized steel belt and concrete have good adhesion, not easy to fall off and loose, so that the buried rubber stop can withstand greater tension and torque.In construction due to the enormous vibration for concrete pouring and fixed not easily, can make the ordinary rubber water-stop produce displacement, avulsion, torsion and appear loose and fall off, so that in the case of large water pressure will produce leakage nomenon, and using edge rubber water-stop steel, due to the steel and concrete, steel belt and rubber won't produce new leakage between seam.Â

Check in buried type rubber water-stop surface are not allowed to have a crack, lack of effect use of defects such as glue, sponge, eccentric center hole does not allow more than a third of the tubular cross section thickness, the surface of the rubber water-stop allow a depth not greater than 2 mm, area is not greater than 16 was dent, bubbles, impurities, Ming scar defects such as no more than around;At the same time, it is important to note that all kinds of rubber stops have its application scope, and the inspection can be sampled after acceptance.To approach of rubber water-stop at the same time should pay attention to whether the storage method is proper, the general should not be in a higher temperature place or with corrosive goods stored at the same time, more not to air, sunlight, such as improper placement shall require the construction unit to move.

Hengshui Jianfeng Engineering Rubber Co.,LTD

Â

address:Renmin road No.1657,Heng shui City,Hebei Province,China

Â

Mobile:+86+