Swiss-Geo2 hdpe ding machine pond nection machinery soudure geomembrane
wtsï¼+8
Parameters:
Voltage: 220VPower: 800WSpeed: 0.4 - 7.5m / minThe maximum amount of overlap: 100mmWelding width: 2 x 12mmSize: 228 x 228 x 170mmWeight: 3.9kg
Application:
- Welding of thermoplastic materials as well as single-ply flexible plastics and modified bitumen in the form of boards, tubes, profiles, lining membranes, coated materials, films, foams, tiles and sheets. The following procedures are possible: overlap welding, welding with rod, with tape, butt welding and melt welding.
- For foaming, ending and sealing of the thermoplastic semi-finished materials and plastic granules.
- Drying of water-damp surfaces.
- Shrinking of heat-shrink sleeves, films, tapes, solder sleeves, preformed and mould part.
- Soldering of copper pipes, solder joints and metal foils.
- Defrosting of frozen water pipes.
- Activating and dissolving of solvent free adhesive and fusion adhesives
- Igniting of wood shavings, paper, coal or straw in furnaces
Readiness of working:
- Fit appropriate nozzle as required
- Connect tool to the s
- Adjust air temperature
- Switch on main switch and heat up the tool for approximately 5 minutes.
Changeable nozzles:
- Do not touch the hot nozzle and make sure to place it on a heat resistant surface because of the fire hazard..
- Put the nozzle on the heater tube and secure the nozzle by the screw on the cap.
- Use nozzles only.
Maintenance:
- Clean polluted air filter with a small brush or replace it
- Clean welding nozzle with a steel brush.
- Check mains cable and plug for electrical and mechanical damage.
Service and repairs:
- The motor switches off automatically when the brush reach their minimum length. Have the tool checked by your service center. The life of the brushes is about 800 hours.
- Repairs should be carried out by authorized service centers only. They guarantee a specialized and reliable service.
- Sorry for not special notice in advance if there would be changes on parameters.
Warning
- Unplug the tools before opening it.
- Incorrect use of hot-air blowers can cause fire and explosion hazardous especially near combustible materials and explosive gases
- Do not touch heater tube and nozzle when they are hot. They may cause burns. Do not point hot air flow in the direction of people or animals.
Tips:1. This machine is welded with steel pressure roller to suite the hot air welding.2. Any customized demands, you can ask us directly. We have professional technicians