| Filter Media | Polypropylene |
| Length | 5", 9.75", 9.8", 10", 20", 30", 40", 50", 60", 70" (According to customers requirements) |
| Inside Diameter | 28mm, 30mm (Special ID is accepted) |
| Outside Diameter | 2.36"(60mm), 2.4"(61mm), 2.5"(63mm), 2.55"(65mm) (Special OD is accepted) |
| Filtration Rating | 1μm, 5μm, 10μm, 20μm, 30μm, 50μm, 75μm, 100μm |
| Gasket/O-ring | Silicone, EPDM, Viton, Buna |
| End Cap | DOE, 222/Flat(SOE), 222/Fin(SOE), 226/Flat(SOE), 226/Fin(SOE) |
Description
PP melt blown filter cartridges are high dirt holding capacity, low pressure drop, high flow rate, good chemical resistance, no fibre release, longer service life and effectively filtration for suspended particle, sediment and other kinds of impurities. PP melt blown cartridges are economical and classical filter media, widely used in liquid prefiltration industries.
Â
Feature
1. PP filter cartridges are mainly applied to most industry standard housings
2. 100% FDA approved safety polypropylene material have a lot of demanding applications
3. Superior PP melt blown filters are high filtration efficiency, consistent good performance
4. PP cartridges are multi-layered construction, high contaminant holding capacity and longe service life
5. Customized special PP melt blown filter cartridges are accepted to meet specific application requirements
6. Many types of end caps are available by thermally-bonded, such as 222/fin, 222/flat, 226/fin, 226/flat etc.
Â
Applications
1. PCB industry
2. Plating solution
3. Food & Beverage
4. Electronic Industry
5. Petrochemical Process
6. Chemicals and Solvents
7. Pre RO/ID water filtration
8. Industrial waste water treatment
Signup today to claim your Discount. Get Started before it's too late!
