[ITEM]
O-RING
[TYPE]
O-rings are primarily used to prevent the loss of a fluid or gas.
However, O-rings can be used as dust seals, drive belts or on rotating shafts.
Most O-ring seals can be classified into of the three arrangements shown below.
Static Seal : Axial seal and radial seal depending on the sealing surfaceDynamic Seal : Rotary, reciprocating and oscillating type
[TECHNICAL DATA]
⢠Materials : Choose appropriate material according to NBR, HNBR, EPDM, Silicone, FPM (Viton), Kalrez, CR rubber, temp.and other working materials.
⢠Temperature : -60°C~+300°C, It depends on the material type. (Heat-resistant)
⢠Fluid Sealed : Choose suitable material depending on fluid or air (oil-resistance and chemical-resistance)
⢠Pressure : For static seal, within 100bar (without Back-up Ring), above 100bar (use Back-up Ring) For dynamic seal, within 50bar (without Back-up Ring), above 50bar (use Back-up Ring)
⢠Speed : Reciprocating - Max. 0.5 m/s. Rotary - Max. 0.5 m/s.
[OTHERS]
GASKET (RUBBER, NON-ASBESTOS)SHEET (RUBBER, NON-ASBESTOS)