Introduction:
The standard operation of JND-SS6000 stretch blow molding machine includes four steps as follow
Step 1, Put the preform into preform container and the conveyor will take the preform to orientation units automatically.
Step 2, Load the preform at neck up to preform holder, and then preform is conveyed into the baking tunnel.
Step 3, After heating, preform is conveyed into the blow station, then close the mold, stretch and blow under low pressure and high pressure, exhaust, open the mold.
Step 4, The finished bottle is taken off by automatic discharging system
Technical Parameter
General Information | JND-SS6000 |
Clamping Force | 40 T |
Clamping Stroke | 80 mm |
Max. Stretching Stroke | 250 mm |
Bottom Moving Stroke | 70 mm |
of Cavities | 6 Cavity |
Theoretical Output | 6500 B(500 ml water bottle)*2 PES |
Mould Thickness | 200 mm |
Electrical System | |
of Heating Zone | 6 Sections |
Total Power (MAX Loaded) | 120 KW |
Container | |
Max. container Volume | 0.75 L |
Neck Diameter Range | 32 mm |
Max. Container Diameter | 70 mm |
Max. Container Height | 200 mm |
Dimension & Weight | |
Blow molding machine | 490 x 220 x 230 CM |
Preform Autoloader | 250 x 180 x270 CM |
Net Weight | 8 T |