Thermoplastic road marking paint

SICAL CHARACTERISTICS

A. Compression Strength

23.8MPa

B. Fluidity

38

C. Abrasion Resistance

56.8

D. Glass Beads

0%/10%/20% /25%/ 30%

E. Softening Temperature

104°C

F. Heating Temperature

180-220°C

G. Drying Time After Marking

Touch dry—3 mins

Full dry—10 mins

H. Shelf Life

Up to 12 months

I. Storage

Store in a tightly sealed container in a cool & dry place

J. Area Of n>

1 Ton thermoplastic paint can mark about 200 m2

PROCESS

A. Clean

Clean intended application area thorough

B. Layout

Outarea where the marking will be placed using titanium dioxide

C. Apply primer

Apply the appropriate amount of primer needed for the surface

D. Melt

Heat paint to be melted using pre-heater

E. Position A

Pour melted paint into big container of road marking machine

Position B

Pour glass beads into small container of road marking machine

F. Mark

Mark thermoplastic g road marking machine

G. Cool

Thermoplastic cool within a period of time

ATTENTION

A. Ensure road surface is stable, dry and clean

B. It is better to apply above 0°C

C. Heating paint in the pre-heater should be between 180-220 °C

D. Lift the heating temperature properly when working in a low temperature environment

E. Mixing the melted paint evenly and keeping it warm for 3-5 mins before marking the road

F. Allow primer to dry before applying paint

G. Primer is applied a few wider than the width of the thermoplastic n>

H. New aslt and concrete must be allowed to cure for a minimum of 30 days before applying paint

Wanting