Installation and adjustment of vibrating screen filterRotary vibrating screen is a high precision fine powder screening machine. It has low noise and high efficiency. It takes 3-5 minutes for rapid net change, and it is completely closed. It is suitable for screening and filtering of materials such as grain, powder and mucus. The basic principle of the three dimensional vibration screening filter (rotary screen) is to transfer the motor's rotation to the three dimensional movement of horizontal, vertical and tilt, and then transfer the motion to the screen. Changing the se angle of the hammer at the top and bottom can change the direction of the raw material.Instructions for use of motor: this series of motors can continuously output rated excitation force when meeting the following conditions. 1, vibration acceleration: no more than 7g (G: gravity acceleration) 2, ambient temperature: no more than 40 C 3, elevation: no more than 1000m 4, power frequency: 50Hz 5, voltage: 380V 6, Wen Sheng: less than 80K (resistance method)Screwing screen installation and adjustment:1, the motor should be fastened to the mounting surface, and the mounting surface must be smooth and smooth.2, the motor can be installed horizontally.3, the motor leads are made of four core rubber cable YZ-500V. When the power supply is supplied, the lead cable is not allowed to be folded rapidly, and is reliably fixed with the vibrating body.4, the motor should have reliable grounding. There is a grounding device in the motor. There is a mark at the end of the lead, and the grounding bolt can also be grounded by using the foot anchor.5. The adjustment of the exciting force.Preparation of the screwed screen before installation:1, check whether the motor signs are consistent with the requirements.2, measure insulation resistance with 500 volt ohmmeter, the value should be dry to the stator winding, and the drying temperature should not exceed 120 C.3, check motor each fastener, beware of loosening.4, check the motor surface has no damage, deformation.5, check whether the rotation is flexible, if abnormal, should be excluded.6, check the power supply, whether it is missing se, and run for 5 minutes.
