RV24S Potentiometer with Switch manufacturer China Customization

Features

-24mm diameter, single-turn industrial panel control

-Carbon film r audio taper

-SPST switch with 1A,3A or 5A 220VAC rating

-Metal shaft and bushing (Plastic PBT end optional)

-Right angel ear-lay terminals (Left or none optional)

-6mm diameter shafts in slot, flat or round and styles

-Standard 15mm or 20mm shaft length

Potentiometers should avoid exposing the potentiometer to a strong atmosre of chemicals such as ammonia, amines, alkali solutions, aromatics, ketones, esters, halocarbons and other chemicals due to the use of synthetic resins such as polycarbonates.

Water-soluble fluxes should be avoided when soldering, otherwise it will adversely affect the metals and other materials of the potentiometer

The wiring design and soldering method should avoid causing the melted tin to flow to the upper plane of the PC board, as shown in Figure 1, which can cause poor

4.Recommended circuit connection

Although the potentiometer resistor is a printed silver layer, in order to improve the reliability of the resistance to vulcanization, a carbon film is usually covered in the second stage of the resistor, if you want low residual resistance, please our company.

During the use of the potentiometer, the surface of the resistive body should avoid condensation or water droplets, otherwise, it will lead to a deterioration or short circuit of the insulation resistance.

7.Stress applied to the terminals

When using a shaft with an excessively long length, its radial shaking momentum will be proportional to the shaft length, and the shaft length should be selected according to actual needs.

9.Installation of the panel

When the product is used in a low temperature environment, such as a car radio or car audio used in cold areas, the company provides comfortable products according to customer requirements, please explain when ordering

The shorter the better the length (at least 5mm) In the case of the width A of the slider, the shorter the length of the handle, the better the feel, the higher the other force point, the worse the feel.

Never keep the operating point away from the slide center the same reason, the shorter the distance between the two from B, the better