Electromagnetic Flowmeter
Technical Data
Suitable Diameter | DN10~DN2600 (below DN25 non-standard, which should be customized) |
Electrodes Materials | 316L (stainless steel), Hastelloy C, Hastelloy B, Titanium, Tantalum |
Suitable Fluid | Liquid with conductive ratio more than 5 μs/cm |
Measuring Range | 0.1~10m/s (extendable to 15m/s) |
Upper Limit of Span | 0.5~10m/s. 1~5m/s recommended |
Accuracy | 0.3%, 0.5%,1.0% |
Output p> | 4~20mADC, load<= 750ohm, 0~3kHz, 5V with source and changeable width. high terminal and effective frequency output , RS485 interface |
Operation Pressure | 1.0MPa, 1.6MPa, 4.0MPa, 16MPa (special) |
Fluid Temperature | -20C~80C, 80C~130C,130C~180C Depending on Lining Material |
Ambient Temperature | Sensor -40C~80C. transducer -15C~50C |
Ambient Humidity | <= 85%RH (at 20C) |
Cable Outlet Size | M20(16) Ã1.5,1/2âNPT |
Power Supply | 220VAC±10%, 50Hz±1Hz, 24VDC±10% |
Power Consumption | <=8W |
Protection Ratings | Integral type: IP65. remote type: sensor IP68,transducer IP65 |
Materials of > | PTFE, soft rubber, hard rubber, PFA, etc |
Process Connection | Flange :ANSI , DIN , JIS ,ISO ,GB standard Thread :NPT ,BSP ,G Tri-clamp connection |
Earthing Materials | 316L (stainless steel), HC, Ti, Ta, Cu |