SIL3 - Safety Integrity Level SIL 3 certification to IEC 61508, certified by Exida/ TUV
Valves successfully tested to Shell Design Evaluation Test, Procedure 77/300 for temperature -29 to 150 degree C (O rings) and -50 to 150 degree C (Lip seals)
Pneumatic shell test conducted at 1.1 times rated pressure to check shell integrity, when required
Features that Add Value:
Double block and bleed (DBB) feature - Valves are designed and tested for automatic cavity relief
Anti-blowout stem design
Coil springs used for consistent seat loading and lower operating torque
Lip seals provided for low temperature services
2/3 stage Stem and 2 stage Body Joint sealing system; Primary O ring and Secondary grate (in 3 stage stem, thrust washer is primary)
Where tight shut off is required, Double piston effect (DPE) seats provided for redundancy in sealing
Versatile Solutions:
Wide portfolio of Side-entry and Top-entry designs
Options: Buried service, Cryogenic
Offered with Electric, Pneumatic and Hydraulic Actuators
In-house Tests Capabilities - Cryogenic Test, Pipe Bending Test, Vacuum Test and Fast Closure Test
ValvTrac⢠RFID tagging offered for reliable digital traceability
Trunnion-mounted Ball Valves -Â Top-entry Design
Special Features:
Accessibility to all the valve internals from the top
In-e maintenance, without disassembling the valve from the pipe
Signup today to claim your Discount. Get Started
before it's too late!
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.
Ok