Fuel Station Red Jacket Submersible Turbine Pump For Fuel Transfer Pump

The Submersible turbine pump motor is the heart of a service station, controlling the flow of fuel through every pipe, to every dispenser and every nozzle. We improved motor delivers higher efficiency and fuel flow and lower power consumption, allowing Red Jacket to continue. Offer you the most advanced Submersible turbine pump.

Submersible pumps can be roughly classified into four types according to their main purposes:Submersible oil pump for a gas station; submersible oil pump for oil depot (refueling ship), a submersible oil pump for unloading oil for tank crane, and submersible oil pump for an oil well. Our company mainly sells submersible pumps for gas stations.

The submersible pump uses the principle of positive pressure push to fundamentally eliminate the gas resistance nomenon and completely solve the problems that the self-priming pump can't solve under a high-temperature environment, high lift and long distance conditions, such as less oil (gas-liquid two-se). , environmental pollution, and even no oil. In addition, the submersible pump of the gas station can have multiple pumps (4-8 guns), and the self-priming pump can only pump one gun. Therefore, the submersible pump simplifies the oil pipebrings great convenience to installation and maintenance. The most cost-effective.

The submersible electric pump can adapt to different types of oil well conditions. The impeller and guide shell of nickel-containing cast iron and the pump shaft of K-500 Monel enable the pump to have a satisfactory service life at maximum strength and load. In order to adapt to the good condition, load bearing and simplified assembly of the components, the multi-stage submersible electric pump adopts three types of full floating type, full pressure type or semi-floating type in the assembly form, and is divided into the radial flow and mixed flow in structure. In terms of use, it is divided into the standard pump, sand control pump, and anti-corrosion pump.Our submersible pump is modeled after a red jacket. We use the same drawings, the quality of the products is very good, and it is exported overseas.

Feature:

1, Best performance, long time service, lower noise.2, Easy to install and service quickly, simple and safe electrical connections. Manifold allows for vertical or horizontal discharge.3, Save time, lower service cost.4, Built with check valve,bypass valve, vacuum valve.5,For diesel,gasosene etc.6, Vapor-free, suction head longer than the suction pump.

Wellhead (1) Tthe wellhead provides structural and pressure containing an interface for the drilling and production equipment.

Surface Equipment (2) Aboveground a system controller combined with a Variable Frequency Drive and related transformer or the patented AAESP Variable Frequency Generator provide controlled power supply to the ESP.Power Cable (3) Motor Lead Extension (9) The electrical main cable and the flat cable motor lead extension with pothead connect to the surface equipment with the ESP motor and well monitoring device.Drain Valve (4) Check Valve (5) Other protective devices are located above the pump discharge. These include the check valve that closes on backflow and prevents back spinning and the drain valve that allows for pulling the ESP without a wet tubing string.Pump (6) The pumping unit itself consists of the multi-stage centrifugal pump housed in a pressure sleeve with the capability of producing capacities up to 100,000 BPD (16,000 m3/d) from depths of up to 15,000 ft (4,575 m).

Intake/Gas Separator/Gas Compressor (7) Immediately below the pump is the intake combined with a gas separator if required. The gas separator allows for trouble-free operation in good conditions with free gas contents of more than 10% to 20%. The AE-ESP Gas Compressor can handle up to 45% of free gas and steam.Protector (8) Located between the motor and pump intake is the protector. The protector isolates the motor from the well fluid and contains the high capacity thrust bearing

Products Shows