CEMS - Online Monitoring System

Water Quality Monitoring System is a facility to measure pollutants such as Chemical Oxygen Demand (COD), Total Phosphates (TP), Total Nitrogen (TN) etc. The required parameters are customized according to the type of factory and discharge regulations. Central Pollution Control Board vide its letter No. B-29016/04/06PCI-1/5401 dated 05.02.2014 issued directions under section 18(1)b of the Water and Air Acts to the State Pollution Control Boards and Pollution Control Committees for directing the 17 categories of highly polluting industries such as Pulp & Paper, Distillery, Sugar, Tanneries, Power Plants, Cement, Oil Refineries, Fertilizer, Chloral Alkali Plants, Dye & Dye Intermediate Units, Pesticides and Pharma Sector, Common Effluent Treatment Plants (CETP) and STPs, Common Bio Medical Waste and Common Hazardous Waste Incinerators for installation of online effluent quality and common emission monitoring systems to help track the discharges of pollutants from these units. Organic Pollutant Monitor  The OPSA-150 is an ultimate organic pollutant monitor that uses HORIBA's proprietary Rotary Cell Length Modulation, The key feature of this device is that it monitors organic pollutant content at drainage systems is able to transmit data with COD monitoring regulations, for monitoring quality of water measuring levels of organic matter at water supply intakes, and as an organic monitor on process lines (phenol meter). Key features  ·          USAPH Approved product. ·          COD, BOD & TSS Online Monitoring by UV - VIS Absorption ·          Measurement of Organic Matter at Water Source ·          Measurement of Organic Matter on the Process Line ·          Continuous Measurement with Low Maintenance ·          Large Measurement Range of 0 to 5.0 Abs ·          Online Monitoring system for stp ·          Zero drift correction is performed in every cycle of measurement which eliminates the effect of any interference on cells. ·          Cell length modulation provides readings from multiple measurements, making available results from various cell lengths. This allows the single device to make measurements on a large range of concentrations from as low as 0 to 0.1 Abs, up to 0 to 5.0 Abs. Features  Sensor that makes full use of Rotary Cell Length Modulation (Patent pending) Zero drift correction is perfomed in every cycle of measurement. This correction can eliminate the effect of any interference on cells. Cell length modulation provides readings from multiple measurements, making available results from various cell lengths. This allows the single device to make measurements on a large range of concentrations from as low as 0 to 0.1 Abs, up to 0 to 5.0 Abs. Measuring Parameters:  BOD , COD , TSS , PH , Flow , Dissolved Oxygen, ORP, Conductivity, Temperature, Turbidity, Ammonium, Nitrate, TOC, DOC, SAC