4T Motorcycle Engine Oil Lubricant Additive Package

●Product Introduce The product can meet API SJ 4T motorcycle oil specification requirements ,through the certification test of honda series motorcycle, also can be used in lubrication of other brand motorcycle.Matched SJ four-stroke motorcycle oil can meet the JASO T903 specification requirements. The 4T Motorcycle Oil Additive Package  is formulated with low base number detergent and dispersant. It has excellent detergency, lubricative and dispersancy. It is developed to formulate SJ, SG engine oils and four stroke motorcycle engine oil. Same with Gear Oil Additive Package and Engine Oil Additive Package, it's also belong to one kinds of additive package. ● Recommended Dosage: API Performance Level Treating Rate(mass%) SJ 6% SG 5.5% ● Product Quality Characteristics & Test Method Item               Typical Value Test Method Kinematic Viscosity (100℃), mm²/s Report  GB/T265, ASTM D445 Flash Point (COC), ℃ >110 GB/T3536, ASTM D92 Total Base Number, mgKOH/g 98 SH/T0251, ASTM D2896 N Content, m% 0.48 SH/T0224, ASTM D5862 Zn Content, m% 1.87 GB/T17476, ASTM D5185 Ca Content, m% 3.25 GB/T17476, ASTM D5185 P Content, m% 1.538 GB/T17476, ASTM D5185 ●Product Storage/Handling/Transportation/Package The 4T Moto Additive storage temperature should not exceed 50 ℃, the maximum temperature does not exceed 60 ℃, when handling and modulating; This product is not flammable, non-explosive, non-corrosive, it is same as general petroleum products in safety, environmental protection, use and other aspects, no need the special protection. The storage, transport and production should meet the requirements of SH/T0164.The maximum temperature should not exceed 75℃, for long-term storage, the maximum temperature should not exceed 45℃. The product is not flammable, explosive, and corrosive. Its safety cause, environmental protection and usage may refer to the general procedures for the common petroleum products.