Quick Details
- Extended height:6m
- max. payload:30kg
- wind load capacity:120km/h
- No. of section:4
- outer tube diameter:98-82-66-51mm
- retracted height:1.95m
- material:aluminum alloy
- color:bronze
- working type:air operated
- installed on:ground, vehicle, concrete etc....
- used for:antenna, camera and lights etc..
- Processing Time:7 days for sample
- Port:Shanghai or Tianjin port
- Supply Ability: 500 Sets Per Month
- Place of Origin:China
- Model Number:TAL-P6-1.95-30
- Brand Name:Talents
- Brand Name:Talents
What is a Pneumatic Mast?
Pneumatic masts are a type of elevation solution using compressed air to raise the central column to its extended height. The masts can either be locking, which each
section locks into place once it reaches its maximum extension - designed for safety and long term use( do not lift down the mast), or non-locking where each section sits on cushion
of air- more appropriate for short time using.
Classification of masts
Model"AT8"---no cable
and no lock, for Short time using and small head load.
Model"AT9"---with lock.
for long time using and large head load.
Model"AT7"---with cable.
for mounting camera, lights or antenna.
Common application
Telecommunications,
Surveillance, Broadcasting, Disaster Recovery, Site Surveys, Energy Production,
Site so on
Mast specification
Available Extended
height:2m to 30m
Head load capacity:5kg
to 300kg.
Lift operation
choose
If no electricity and head load is not heavy, lift control could be foot pump or hand pump---manual lift.
If thers is electricity and head load is heavy, lift control should be air compressor, easily and quickly.
What is the data sheet of Pneumatic Mast?
No.
1
extended height
6m
2
retracted height
1.95m
3
max. payload
30kg
4
No. of section
4
5
outer tube diameter
98-82-66-51mm
6
wind load capacity
max. 120km/h
1.check the mast in good condition
2.fixed
the mast on the ground. tripod fixed diameter is 3.4m,guy wire fixed diameter is 8m.
3.air
inlet of control valve connect with air compressor.
4.air
outlet of control valve connect wtih the mast.
5.
once all mounted, you must keep the lifting control valve handle bar in middle location. (it make the air do not come into mast)
6.open
the air compressor switch, at same time adjust the pessure regulating switch to reach 0.2MPa which the pressure gauge shows.
7.then
pull up the lifting valve handle bar, mast will rise.
8.if
you want to make the mast stop in some height, just make the handle bar in middle.
9. when
lift down the mast, please pull down the lifting control valve handle bar..
What's the accessories?
No.
Type
Quantity
1
air compressor or air pump with air hose
1pc
2
car clamp or tripod
1pc
3
guy wires with ground anchor
4pcs
4
control valve
1pc
What's the package?
Each one set of mast and accessories put into a carton
What's the certification?
How to contact?