Charcoal

Charcoal is produced using an oxygen-free process that heats natural wood in order to remove the air and water and to create a carbon product that will burn significantly longer than wood. Used as a source of fuel for grilling foods, Charcoal is manufactured for Charcoal grills in the form of briquettes, lumps or extruded Charcoal. After the Charcoal is ignited, it begins to form a white ash that coats the outside of each piece of Charcoal. Once it is fully covered with ash, which should occur within 15 minutes, the Charcoal is providing significant heat for cooking and is ready to use. Lump Charcoal contains no additives as fillers or binders and is simply carbonized wood. Containing a high percentage of carbon makes the Lump Charcoal last longer, burns hotter and create less ash residue. Lump Charcoal is generally used in food smokers where the Charcoal needs to burn for longer periods of time in order to adequately smoke the meats or fish within the smoker. Briquettes are the most common type of Charcoal being manufactured by mixing powdered Charcoal with a binder and various fillers. The binder helps to hold the briquette together as it is formed into small round-cornered squares of carbon but it also works as a means to decrease the temperature at which the briquette burns. Fillers may be used to make the briquette easier to ignite or simply to add bulk to the product which, if low grade binders are used, can decrease the quality of the briquette since the binder reduces the amount of carbon in the briquette. Extruded Charcoal does not use a binder for the production of the extruded product. Instead, bits of raw ground wood or carbonized wood are used to produce the Charcoal. This manufacturing procedure is the same process used to make the Japanese product known as binchotan which some feel is the highest quality Charcoal available. Made from holm oak wood, binchotan looks like a long burned stick which is similar to what has occurred to produce the product. The holm oak is burned at exceptionally high temperatures and then is removed immediately to be extinguished with burned ash, resulting in a product that is very hard and very high in carbon content. Although, traditional charcoal has lower purity than lump charcoal or charcoal briquettes. Traditional charcoal contains mineral sand and clay that is picked up by the wood and its bark, and it contains more ash than the briquettes. Purification of traditional charcoal can be done by removing the ash through a strainer, leaving fragments of mostly good charcoal. After milling this charcoal from the sifting process, the material is put into briquettes. A binder is mixed with the milled charcoal and pressed into briquettes