Makro Teknik Glue MT 100 SPRAY

Where to use? It is used for bonding polythene and rubber isolation, acoustic isolation to pipe and air duct installations. It is produced as an alternative to rubber-based products. After the application, the surfaces should be bonded quickly. Maximum adhesive strength is obtained for durability, if application is made within the appropriate drying time. Since the drying time of adhesive and reaction will change due to the weather change on the construction site, this product is recommended when fast drying is required in the application conditions. How to use? Before the application, remove any oil, dirt and dust on the surface to be applied. Apply Makro Teknik Glue MT-100 to cover the entire surface. After the applied surface remained open for the waiting period, the bonding process is realized by placing the isolation on the surface. The waiting period may vary depending on the amount of adhesive and ambient temperature. In order to obtain maximum adhesive resistance, the attention should be paid that the waiting period for MT-100 is less than MT 70. Properties Appearance: Honey-colored liquid Chemical composition: Synthetic rubber, resin and solvents. Viscosity DIN 53211: 10±2 sn (8 mm 20 ºC Fortkap) Dry substance content : 40%+ 1 Specific Gravity: Approx. 1.2 gr/cm³ Boiling point : 40° - 70°C Volatility weight % : Approx. 60% Flash Point: It does not flash Drying point: 5 - 10 min. (depending on the ambient temperature).