3SC - Solar Centrifugal Pump

MPPT function Maximum Power Point Tracking is electronic tracking - usually digital. The charge controller looks at the output of the panels and compares it to the battery voltage. It then figures out what is the best power that the panel can put out to charge the battery. It takes this and converts it to best voltage to get maximum AMPS into the battery. (Remember, it is Amps into the battery that counts). Most modern MPPT's are around 93-97% efficient in the conversion. You typically get a 20 to 45% power gain in winter and 10-15% in summer. Actual gain can vary widely depending weather, temperature, battery state of charge,and other factors. Soft start function HYBSUN controller control the the motor operation continues,operating power is gradually increased until motor reaches it;s maximum speed.As a result,service lifetime of both the motor and controller and protection switch gear and prolonged. Dry running protection HYBSUN solar submersible pump’s controller that offers intelligent detection function of water the water level dropped below the pump inlet, the HYBSUN controller will stop the pump and indicates Well LED. Stop the pump automatically,Restarts automatically 30mins,Flexible installation. Adjustable speed HYBSUN solar controller with adjustable speed function.User could set different working speed to adjust water capacity and head according actual water demand to avoid water waste. Meanwhile,which also reduces the mechanical wear of the motor as well as the start up loads on the PV array Self-protecting functions Error wiring protection Over/under-voltage protection Overload protection phase-loss protection High working temperature protection