Quick Details
- Processing Time:-
- Port:-
- Supply Ability: -
- Brand Name:-
Capacity:120G
With reasonable cost, customer can significantly improve speed for PC made out of traditional hard disk.
Product Detail specification :
1. Capacity: 120GB
2. Sequential Data Read/Write speed: 10X faster than 7200RPM hard drive.
3. Data retention: 10 years
4. MTBF:1,000,000 Hours
5. WARRANTY : 3 YEARS
6. Outline: standard 2.5 inch SSD.
7. Interface: SATA III, compatible with SATA 1.5/ 3.0/ 6.0Gb/s
8. Operating temperature range form 0℃ to +70℃
9. SMART power management.
Inside the package:
one SSD,
one manual,
one blister,
one box.
Attention:
No SATA cable or adapter inside.
Please check if there is mechanical damage on the package before install SSD.
If you see a failure, please record and report failure mode for troubleshooting.
About read/write speed, the reference speed value on this product page is based on our evaluation on our test PC. It may vary from different hardware in customer side. The evaluation
was done on SATAIII interface, speed will be lower if it's SATAII connection.
About SSD detection, our SSD compatibility has been evaluated in design and development phase, we choose most commonly used controller to maximize compatibility. In real world, there
could be very few compatibility issue, if unfortunately you met such issue please first check hardware connection is correct, if problem stays please contact us for
resolution.
About system installation, there are a few case customer failed to install SSD in first try, in such scenario please double confirm the boot disk is functioning properly. A colone
software (e.g. AOMEI Partition Assistant) could help you simplify the process.
About temperature, this product doesn't support real time temperature measurement. The temperature value you see from evaluation tool (e.g. SMI SSDToolbox) is a default value set in
S.M.A.R.T, it doesn't mean the actual temperature.
