Vertical Roller Mill

Application of Vertical Roller Mill: Vertical mill are suitable for huge capacity producing, widely used in grinding non-flammable and non-explosive materials under 9.3(the Moh's hardness), such as quartz, feldspar, calcite, talcum, barite, fluorite, iron ore, copper ore quartz, especially for slag, cement clinker, zircon sand, fly ash and carborundum, coal, etc. Working Principle of Vertical Roller Mill The grinding disc is driving by motor through reducer. The material falls to grinding disc from the feed opening. The materials are driven to the edge of disc by the centrifugal force and crushed into fine powders by rollers. Then, the hot air from the nozzle take the fine powder to high effiency classsifer.The qualified powder are taken by the air to the powder collector to be collected, while the unqualified powder are sent back for regrinding.  Advantages of Vertical Roller Mill 1. High grinding efficiency: save 20~30% power consumption compared with the ball mill. With the increasing of moisture content, it can save more and more electricity. 2. Strong drying capacity: dry and grind raw materials with moisture content as much as 15%. 3. Mutifunction: crushing, drying, grinding, separating and conveying. 4. Low noises and little dust: no direct contact between the grinding rollers and grinding disc, so metallic impact is avoided and its noises is 20~25 decibels lower. Totally closed negative pressure operation has employed by this vertical grinding mill, so there is no dust during the operation. 5. Low wear rate and little metallic pollution: its metal wear is only 5~10g/t Specifications of Vertical Roller Mill: Model LM130K LM150K LM170K LM190K LM220K LM240K Turnplate diameter (mm) 1300 1500 1700 1900 2200 2400 Capacity (t/h) 10~30 13~40 18~57 23~72 36~114 41~128 Final product size μm 170~45 170~45 170~45 170~45 170~45 170~45 mesh 80~325 80~325 80~325 80~325 80~325 80~325 Final product water percentage ≤1% ≤1% ≤1% ≤1% ≤1% ≤1% Max. input size (mm) <38 <40 <42 <45 <50 <55 Best water percentage of raw material <4% <4% <4% <4% <4% <4% Drying needed if water percentage is more than <15% <15% <15% <15% <15% <15% Input wind temperature (°C) <350 <350 <350 <350 <350 <350 Output wind temperature (°C) 70~95 70~95 70~95 70~95 70~95 70~95 Main motor power (KW) 185~220 250~280 355~400 450~500 710~800 800~900 Overall dimension L (mm) 3500 4200 4700 8500 10200 11700 W (mm) 3400 3900 4500 5600 6700 7700 H (mm) 5800 7100 8300 8800 10600 12200 Weight (t) 48 75 90 100 125 160