Wireless Wind Speed Sensor Anemometer For Crane Solar Powered

Solar Wireless Anemometer Operating Instructions A、Main Parameters： 1、Power voltage: host DC12-24, wireless wind speed sensor solar power 2、Working current: host 100ma, wireless wind speed sensor 10ma (battery 3.6V, 6.5AH; Solar panel 3W) 3、Alarm wind velocity：5-40m/S adjustable 4、 Power-off wind velocity ：5-40m/S adjustable 5、Control contact capacity ：AC220V/5A；DC30V5A 6、Working mode： Continuous 7、Transmission distance: 600 meters (visual range), the work site is subject to the actual occlusion.   B、 Installation and Wiring 1、The host should be fixed at the convenient place of staff observation 2、The wind speed sensor is fixed on the crane or the tower where is unobstructed. There are no tall buildings between the host computers if the distance is far. 3、After the bolts are tightened, the upper part of the flange plate is welded to the steel structure with weld length of 10mm. 4、The host power cord is three - core plug wire with red positive and black negative. 5、For the host seven-core plug cord, the blue cord is control interlock (normally closed), and yellow cord is control interlock (normally open), black cord is common terminal. 6、The DC plug on the solar panel is connected to the sensor to enter the working status, which is waterproof with mackintosh adhesive tape. 7、When the crane boom is in the horizontal, the sensor will not emit signals. When the boom is lifted about 20 degrees, the power is switched on and the sensor enters into the working status.