Dear sir, I am looking to buy this Horizontal centrifugal gear type pump with the specifications as under: Electric Driven Horizontal Centrifugal Gear Type Pump with out motor. And Starter for the pumping of NG Waste ACID Type (G-8) Centrifugal (Gear Type) Suction: 1-1/2 x 1-1/2 Both Ends BSP Threaded )Suction Head Flooded By Gravity) Discharge Head 23 FT Capacity ; 22GPM , RPM 900 Direction of Rotation: Clockwise Facing Drive Side Fluid: NG (Nitroglycerine) Waste Acid; SP. Gravity; 1.69 Specification of NG Spent ACID H2S04 = 70.72% HNO3 = 12.14% H2O= 13.15% NG = 03% Temperature = 16.18C PN = 150 PSI Bearing Type: Internal Sleeve Bearing Lubrication: By Pumped Fluid Driving Shaft Diameter = ? PCD ( Pump Foundation 2.5/8 x 1.1/4 x ? (Thickness) No of Hole = 04 Nos , Hole Size = 9/32 Heigh (Foundation to Driving Shaft Centre = 1-11/32 Wiight: 07 LB Construction Material Casting Housing Austenitic Stainless Steel 316 Driving Shafts; Stainless Steel 1.4408 Gear ; PTFE / Suitable for NG Waste ACID Seal: Gland Packing Wear Plates : Cermic Internal Sleeve (Bearing) PTFE/Suitable for NG waste Acid , Gland Box : C 20 Recommended Spare Parts for two Years Service Gear : 02 Set Wear Plate: 08 Nos Internal Sleeve: 08 Nos O Ring (Viton O Ring) 04 Nos Technical Documentation in English : 3 sets Drawing of Pump Operation Maintenance and Lubrication Manual Spare Parts List for PUMP, Cost of pump and spare parts should be indicated separately. Delivery time and any other information should be stated clearly. Looking forward for your compettive rates and assistance in this regard. You can do all your corespondance. Your urgent response will be highly appreciated. Thanking You, S Iqbal Show More