AC motor stator winding Buyer and Importer

Dear Sir/Madam, This is Richard Lester from UK. I'm looking for products with the following specifications: A stator must have a OUTER Diameter of 110mm, stack height of 60mm and a total height including windings of no greater than 110mm. The Stator should be 2 poles and needs a temperature limiting switch on both poles to stop damage if the pump runs too hot. The 4 wires from the stator (2 live poles, common neutral and earth,) should be 500mm long protruding from the stack. The rotor must be able to accept a 19mm shaft inserted into it. The outer diameter of the rotor can be set by your instruction to heighten efficiency and power. The motor will run using 240v ac European mains power. The switching using a capacitor will be done externally, it only needs the 2 poles and nothing more. Thank you, Richardr of 110mm, stack height of 60mm and a total height including windings of no greater than 110mm. The Stator should be 2 poles and needs a temperature limiting switch on both poles to stop damage if the pump runs too hot. The 4 wires from the stator (2 live poles, common neutral and earth,) should be 500mm long protruding from the stack. The rotor must be able to accept a 19mm shaft inserted into it. The outer diameter of the rotor can be set by your instruction to heighten efficiency and power. The motor will run using 240v ac European mains power. The switching using a capacitor will be done externally, it only needs the 2 poles and nothing more. Thank you, Richard Show More