P3M Hand Sanitizer Gel
Material Safety Data Sheet
Product: Hand saniter gelÂ
Supplier: PPPM SOLUTIONS (M) SDN BHD
Brand: P3MÂ
EMERGENCY OVERVIEW
This information is based on findings from related or similar materials.
Eye: irritant
Skin: no irritation
Ingestion: vast ingestion may cause diarrhea and stomach irritation
Inhalation: vast inhalation may irritant to nose, throat and lung, may cause cough, breathe hard and asthma,Â
etc.Â
Potential Health Effects, Signs and Symptoms of Exposure:
Primary Route of Entry: No specific information available.
Eye: No specific information available. Contains materials that are essentially non irritating, but mayÂ
cause slight transient irritation.
Skin: No specific information available.Â
Ingestion: No specific information available. Contains materials that are considered to be practically nondiv dir="auto">Inhalation: No specific information available. Low volatility makes vapor inhalation unlikely. Aerosol can beÂ
irritating.
Sub-Chronic Effects: No specific information available. Limited tests showed no evidence of teratogenicity inÂ
animals. A lifetime skin painting study with mice showed no evidence of carcinogenicity.
NOTE: Refer to Section 11, Information for Details
ALCOHOL，WATER，CARBOMER，PROPANEDIOL, TRIETHANOLAMINE
First Aid for Eye: Flush eyes with water for 15 minutes, including under eyelids. If irritation continues, seekÂ
medical
attention.
First Aid for Skin: Remove contaminated clothing and wash area with soap and water for 15 minutes.
First Aid for Inhalation: In case of exposure to a high concentration of vapor or mist, remove person to freshÂ
air. If breathing has stopped, administer artificial respiration and seek medical attention.
First Aid for Ingestion: If appreciable quantities are swallowed, seek medical attention.
Flash Point(°F/°C) Flammable Limit(vol%) Auto-ignition Temperature(vol%)
>212 °F/100 ºC Setaflash No Data No Data
Method:
Extinguishing Media: Use carbon dioxide or dry chemical for small fires; aqueous foam or water for largeÂ
fires.
Fire Fighting Instructions: Remove all ignition sources. Wear self-contained breathing apparatus andÂ
complete personal protective equipment when entering confined areas where potential for exposure toÂ
vapors or
products of combustion exists.
Unusual Hazards: High temperatures and fire conditions may cause rapid and uncontrolled polymerizationÂ
which can result in explosions and the violent rupture of storage vessels or containers. Avoid the use of a
stream of water to control fires since frothing can occur.
Spill or Release Procedures -
Spontaneous polymerization can occur. Although material is non-flammable please try to eliminate all ignition
sources. Use eye and skin protection. Place leaking containers in a well ventilated area. Dike and recoverÂ
large
spills. Soak up small spills with inert solids (such as vermiculite, clay) and sweep/shovel into disposalÂ
container.
Wash spill area with strong detregent and water solution; rinse with water, but minimize water use duringÂ
cleanup.
Do not flush to sewer! Dispose and report per regulatory requirements if necessary. Please preventÂ
washings from entering waterways.
Handling: Avoid with skin and eyes. Avoid breathing vapor. Keep container closed when not in use.Â
Avoid
prolonged exposure to light. Wash contaminated clothing thoroughly before reuse. Wash skin thoroughly with
soap and water after handling. Isopropol Alcohol can be used to remove sticky residue from hands. SolventsÂ
should not be used to clean skin because of increased penetration potential.
When handling gel for product use, do not heat above 100ºF/38ºC or disassociation of resins in product may
occur. Material is UV light sensitive, avoid prolonged exposure to light/heat.
Storage: Store in a cool place, away from heat and light. Store at temperatures below 100°F/38ºC.
Explosion Hazard: High temperatures and fire conditions may cause rapid and uncontrolled polymerizationÂ
which can result in explosions and the violent rupture of storage vessels or containers.
PERSONAL PROTECTIVE EQUIPMENT
General to identify additional Personal Protective Equipment (PPE) requirements, it is recommended that a
hazard assessment be conducted before using this product .Â
Eyes: Avoid eye Ensure eye wash is available. When removing product with an electric file weÂ
recommend the use of safety googles.
Respiratory Protection: May be used with an air purifier.
Skin: Avoid with skin. If to skin occurs remove with warm water and soap and isopropylÂ
alcohol.Â
Appearance Odor & Odor Threshold Specific Gravity Viscosity % Volatile
Clear, viscous
liquid
characteristic acrylate odor NA (H2O=1) : 1.15 N/DA By Volume: < 0.5
BoilingÂ
Point
FreezingÂ
Point
Decompositio
n
Temperature
Octanol/Wate
r
Partitioning
Coefficient
Log Po/w
Vapor
Pressure:
Vapor
Density
Evaporation
Rate
Ignition Solubility
In Water
(20°C)
N/A N/A N/A (mm Hg) @
20 C:<
0.01
No Data No Data No Data Insoluable
Flash Point(°F/°C) Flammable Limit(vol%) Auto-ignition Temperature(vol%)
>212 °F/100 ºC Setaflash No Data No Data
Stability: Normally Stable
 Incompatibility (Materials to Avoid): Polymerization initiators including peroxides, strong oxidizing
agents, copper, copper alloys, carbon steel, iron, rust and string bases.
Hazardous Decomposition Products: Fumes produced when heated to decomposition may include:
carbon monoxide, carbon dioxide.
Hazardous Polymerization: May occur -- Uncontrolled polymerization may cause rapid evolution of
Heat and increased pressure that could result in violent rupture of sealed storage vessels or containers.
Conditions to Avoid:
Storage >100°F/38ºC , exposure to light, loss of dissolved air, loss of polymerization inhibitor, contaminationÂ
with incompatible materials.
Acute Oral e DermalÂ
>
Acute Inhalation
>
Irritation - skin Irritation - Eye
No informationÂ
available
No informationÂ
available
No informationÂ
available
No informationÂ
available
No informationÂ
available
Since this product contains a very low concentration of active components, the primary information isÂ
derived from the oligomers.
Further hazardous properties cannot be excluded. The product should be handled with care when dealing withÂ
chemicals.
Sensitization Mutagenicity Sub-chronic >
No information available No information available No information available
Eco Information
Acute ish: NDA Acute nvertebrates :NDA Acute lgae: NDA
Bioconcentration ewage Bacteria:NDA
Chemical Fate Information
Biodegradability N/DA
Chemical Oxygen Demand N/DA
To the best of our knowledge, the eco and chemical fate properties have not been thoroughly investigated.
Do not allow to enter drinking water supplies, wastewater, or soil.
Disposal method: Single units to be disposed of with normal waste removal.Â
Ensure you comply with any federal, state, and local regulations.
DOT (49 CFR 172)
Proper Shipping Name: Non-Regulated Material
Identification N/A
Marine Pollutant: No
Special Provisions: None
Emergency Response Guidebook (ERG) #: N/A
IATA (DGR):
Proper Shipping Name: Non-Regulated Material
Class or Division: N/A
UN or ID N/A
Packaging Instructions: None
Emergency Response Guidance (ICAO)#: N/A
IMO (IMDG):
Proper Shipping Name: Non-Regulated Material
Class or Division: N/A
UN or ID N/A
Special Provisions & Stowage/Segregation: None
Emergency Schedule (EmS)#: N/A
Other Information: Flash point >100ºC
Poison Schedule: A poison schedule has not been allocated to this product using the Standard forÂ
the uniform scheduling of Drugs and Poisons (SUSDP)
Disclaimer: The information presented herein was obtained from sources considered to be reliable. However,
this information is provided without any warranty, expressed or implied, regarding its correctness or suitability
for consumers intended use and/or application. For this and other reasons, we assume no responsibility andÂ
expressly disclaim liability for loss, damage or expense arising out of any way connected with the handling,Â
storage, use or disposal of the product. This MSDS was prepared expressly for this product. Use theÂ
materials only as directed. If the product is used as a component of another product, the informationÂ
contained within the MSDS may not be applicable.
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.
Ok
