Lanxess Durethan BKV 50 H2.0 EF DUS30 901510 Nylon 6, Glass Fiber Reinforced/PA6+50%GF

PA6, injection molding grade, 50% glass fibers, good heat-ageing resistanceAdvantages:50% glass fibers reinforcedGood resistanceGood flow abilityGood heat-ageing stabilizedGood suitability to surface treatmentsTypical applications/ end uses:It is used in many industries e.g. automotive, E & E, medical, house appliance and more, good mechanical properties and process-ability also are suitable for various structural parts.Processing guideMaterial handling:PA (nylon) materials must be properly dried in order to provide parts with optimum strength and toughness. Nylon materials are hygroscopic and will become degraded by excessive moisture during the injection molding process.Products are supplied in moisture-protected containers and drying prior to molding is not required. If drying becomes necessary, a dehumidifying or desiccant dryer operating at 80 °C is recommended. Drying time is dependent on moisture level, but 4-6 hours is generally sufficient. Make sure final moisture content must be less than 0.2%.Typical profile :Melt temperature: 220-250°CMold temperature: 70-90°C, but temperatures of as low as 45 °C and as high as 105 °C can be used where applicable.Injection pressure: 70-90MPaFill rate:Fast fill rates are recommended to ensure uniform melt delivery to the cavity and prevent premature freezing.Surface appearance is directly affected by injection rate.